4-16
X8DTL-3/X8DTL-i/X8DTL-3F/X8DTL-iF User's Manual
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to boot the computer using a network connection as specifi ed. The
default setting for Onboard LAN1 is Enabled. The default setting for Onboard
LAN2 is Disabled.
Load Onboard SAS Option ROM (Available when SAS is enabled on the
X8DTL-3/-3F)
Select Enabled to boot the computer using a SAS connection. The options are
Enabled and Disabled.
Boots Graphics Adapter Priority
Use this feature to specify which graphics controller to be used as the primary boot
device. The options are Onboard VGA and Offboard VGA.
Super IO Device Confi guration
Serial Port1 Address/ Serial Port2 Address
This option specifi es the base I/O port address and the Interrupt Request address
of Serial Port 1 or Serial Port 2. Select Disabled to prevent the serial port from ac-
cessing any system resources. When this option is set to Disabled, the serial port
physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8
as its I/O port address and IRQ 4 as its interrupt address. The options for Serial
Port1 are Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3. The options for
Serial Port2 are Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, and 2E8/IRQ3.
Serial Port 2 Attribute
This feature allows the user to set Serial Port 2 as a normal serial port or a virtual
COM port for Serial-Over-LAN (SOL). The options are SOL and COM.
Remote Access Confi guration
Remote Access
This allows the user to enable Remote Access support. The options are Enabled
and Disabled. If Remote Access is set to Enabled, the following items will display:
Serial Port Number
This feature allows the user to decide which serial port to use for Console Redirec-
tion. The options are COM 1 and COM 2.
Base Address, IRQ
This item displays the based address and IRQ of the serial port specifi ed above.
The default setting is 2F8h, 3.
To Next Page
Loading...
Need help?
General
