How to troubleshoot SureCall Fusion4Home Extender when it has no power?
If your SureCall Extender has no power: * Verify that the switch on the power supply is turned on and the red LED is ON. * Connect the power supply to an alternate power source. * Ensure the power source is not controlled by a switch that can remove power from the outlet. * Check the green POWER LED on the signal booster.
Why is the red LED solid on my SureCall Fusion4Home Extender?
A solid red LED on your SureCall Extender indicates that the band is off. This can occur if a red light has been flashing for an extended period, causing the band to automatically shut off. It can also happen if the booster attenuation has been turned all the way down.
What does a solid yellow LED mean on SureCall Extender?
A solid yellow LED on your SureCall Extender indicates that the band is inactive. The light is off while the band is active.
General| Uplink Frequency Range | 698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 MHz |
|---|---|
| Downlink Frequency Range | 728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 MHz |
| Max Gain | 72 dB |
| Noise Figure | 5 dB |
| Gain | 72 dB |
| Max Output Power | 1 Watt EIRP |
| Frequency Bands | 700 MHz, 1900 MHz, AWS (1700/2100 MHz) |
| VSWR | ≤2.0 |
| Type | Signal Booster |
| Supported Carriers | AT&T, T-Mobile, Verizon, Sprint, US Cellular |
| Indoor Antenna | Included |
| Impedance | 50 Ohm |
| Bands Supported | B12, B13, B5, B2, B4 |
| Outdoor Antenna | Omni-directional |
Instructions on locating the optimal area for signal reception.
Guidance on mounting the external antenna, including Yagi and Omni types.
Steps for installing indoor antennas, dome and panel types, with separation guidelines.
Instructions for positioning and connecting the main signal booster unit.
How to adjust gain dials based on coverage area and antenna separation.
Details regarding warranty exclusions, liability limits, and legal considerations.
Essential safety precautions, device registration, and operating guidelines.
To Next Page
