SureShade ATF-SG - Pre-loading the Canvas

INSTALLATION
26
© 2018 Rodan Enterprises LLC t/a SureShade®
ATF Installation Guide
4. SECURING THE ROLLER ASSEMBLY
NOTICE
The zipper of the canvas should be facing aft and on top of the roller when installed.
A. Slide the roller assembly onto the actuators.
B. Ensure roller clamps are aligned over “Place Roller Clamp Here” stickers (2 inches in from the end of
the actuator main tube). (See Figure 15.)
C. Secure the roller in place using the provided 1/4"- 20 x 3/4" socket head cap screws.
WARRANTY REQUIREMENT:
Place roller Clamp Here
Roller Clamp
2"
Sticker
Figure 15 – Securing Roller Assembly