Survision Micropak 3 - Default Chapter; Table of Contents

1. Installation location
1.1 - Possible installation locations
1.2 - General installation rules
1.3 - Specic installation rules for car-parks and for normal toll installation when
reading from the front
1.4 - Specic rules for ceiling installation when reading from the front
1.5 - Specic rules for installations in car-parks and normal toll installations
when reading from the rear
2. Assembly
2.1- Assembly and power supply of the NANOPAK Totem
2.1.1 - Assembly procedure with weak electric current
2.1.2 - Assembly procedure with strong electric current
2.1.3 - Installation procedure for totems assembled by SURVISION in factory
2.2 - Assembly of MICROPAK
2.2.1 - Characteristics of the MICROPAK
2.2.2 - Attachment of the support bracket to the wall using the xation kit
with angular displacement provided by SURVISION
2.2.3 - Fixation of support bracket to the ceiling using the xation kit with
anglular displacement provided by SURVISION
2.2.4 - Assembly of AMPHENOL connector
2.2.5 - Diagram of MICROPAK power supply connector
2.3 - Assembly of VISIPAK
2.3.1 - VISIPAK features
2.3.2 - Support bracket installation procedure
2.3.3 - Particular case of SURVISION graduated angle support bracket for
VISIPAK
2.3.4 - Assembly of AMPHENOL connector for VISIPAK
2.3.5 - Assembly of the visor
3. Aiming/Settings adjustment
3.1 - Procedure of adjustment of SURVISION cameras
4. Maintenance
4.1 - Preventative maintenance
4.2 - Firmware update
4.3 - Curative maintenance
4.4 -RMA procedure
Table of Contents