Suunto D3 - 4.4.2. SET FREE MODE

44
4.4.2. SET FREE MODE
To set the FREE Mode:
1. In the Setting Mode, press S four (4) times to select the Dive Setting Mode
(Fig. 4.10.).
2. Wait two seconds until the Dive Setting Mode activates automatically. The
enable/disable status [On/OFF] starts to blink on the display and the selected dive
mode (GAUGE or FREE) is displayed (Fig. 4.11.)
While the enable/disable status [On/OFF] is selected (blinking) press + or - to
change the status.
3. Press S to change the selection in the following sequence:
->On/OFF status -> GAUGE/FREE Mode
When the dive mode is selected (blinking) press + or - to change the mode to
FREE.
4. After you have set the FREE, press the M button to save the settings and to
return to the Setting Mode [SET].