Pairing
●
SKIP: skip pairing
●
BELT: pair HR belt
NOTE: Sounds do not work while the backlight is on.
13.1 Sleep mode and initial settings
To change the initial settings, you have to put the device into sleep mode.
To put the device into sleep mode:
1. After the last step of general settings, when the device asks you to confirm
that the setting changes are done, keep pressed until the device goes
into sleep mode.
2. Press any button to activate the device again.
3. Set the initial settings, see Chapter 4 Getting started on page 8.
NOTE: When replacing the battery, only the time and date change. The device
remembers your previous initial settings and recorded exercises.
Example: adjusting alarm settings
When the alarm is on, is shown on the display.
To set the alarm on/off:
1. In the time view, keep pressed to enter the settings.
2. Browse to ALARM with and confirm with .
3. Set the alarm ON or OFF with and . Confirm with .
4. Set the alarm time with and . Confirm with .
29
en
To Next Page
Loading...
