56
NOTE:
To make sure that the emergency stop switch
operates properly, stop the engine occasionally
by pulling out the lock plate, while operating the
engine at idling speed.
MOORING
The motor should be tilted up out of the water
when you moor the boat in shallow water or if
the motor will not be used for some time, to pro-
tect it from damage by underwater obstacles at
low tide or corrosion from salt water.
Refer to the TILT LOCK LEVER section for
details on how to tilt up the motor.
NOTICE
Improperly securing your boat may cause
damage to your boat or motor, or other prop-
erty damage.
Do not allow your motor to rub against quay
walls, piers or other boats when the boat is
tied up.
OPERATING THE TROLL MODE
MULTI-FUNCTION GAUGE
Switching to TROLL Mode
Press and hold the [MENU] button during cruis-
ing operation at Trolling Speed (minimum
speed), and this will switch the operation to
TROLL Mode.
For the Trolling Speed, the desired engine
speed can be set and maintained within the
range from 700 r/min to 1200 r/min using the
[ ] or [ ] button.
NOTE:
Please contact your authorized Suzuki Marine
Dealer for more information.
Setting the Troll Mode
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. When the [MENU] button is pressed and
held in the multi-function gauge screen, the
confirmation message “Start Troll Mode?” is
displayed.
To Next Page
Loading...
