26
OPERATION
BEFORE ATTEMPTING TO START THE
ENGINE
Using BUILT-IN FUEL TANK
1. The motor has been lowered into the water.
2. Turn the air-vent screw on top of the fuel
tank cap fully counterclockwise to open the
vent.
3. Turn the fuel cock lever to left.
NOTE:
When turning the fuel cock lever to left, fuel flow
from the built-in tank.
4. Disconnect the fuel line of the separate fuel
tank from the fuel connector on the engine
side (If the separate fuel tank used).
Install the fuel connector cap 1 to fuel con-
nector.
NOTE:
When using the built-in fuel tank, disconnect
the fuel line of the separate fuel tank from the
fuel connector on the engine side. If not, the
fuel from the built-in tank may not flow correctly.
5. Make sure that the motor is in “NEUTRAL”.
NOTICE
If spilled gasoline is just left on painted
surface, it may cause a stain or discolora-
tion of the surface coating.
Wipe off any spilled gasoline immediately
with a soft cloth etc.
NEUTRAL
To Next Page
Loading...
