2-6
IGNITION SWITCH
To close the ignition key-hole shutter:
Push the key-hole shutter knob 1 to close
the key-hole shutter.
To open the ignition key-hole shutter:
1. Match the ignition key head to the hole at
the right of the ignition switch.
2. Push the key to the bottom of the key-
hole shutter opener 2.
NOTE:
• Apply anti-freeze chemicals when atmo-
spheric temperature becomes less than
freezing point to avoid ignition key-hole
shutter freezing.
• Spray anti-corrosion chemicals to the
key-hole shutter to avoid shutter corro-
sion trouble.
Tai Nguyen; ; 06.02.2022 22:42.
To Next Page
Loading...
