2-11
CLOCK 6
Time is shown when the ignition switch is in
the “ON” position. The clock has a 12-hour
display. Follow the procedure below to
adjust the clock.
1. To adjust the clock, press and hold the
SEL button 1 and the ADJ button 2
simultaneously for 2 seconds until the
clock display blinks when adjusting
clock.
2. Push the SEL button 1 to adjust the
hour display.
3. Push the ADJ button 2 to adjust the
minute display.
4. Press and hold the SEL button 1 and
the ADJ button 2 simultaneously for 2
seconds to return to the clock mode.
NOTE:
• When the SEL button 1 or ADJ button
2 is pressed and held, the display will
increase continuously.
• The clock can be adjusted when the igni-
tion switch is in the “ON” position.
• This clock is powered by the battery of
the motorcycle. If your motorcycle is to
be left unused more than two months,
remove the battery from the motorcycle.
GEAR POSITION INDICATOR 7
The gear position indicator indicates gear
position. This indicator displays “0” when the
transmission is in neutral.
Tai Nguyen; ; 06.02.2022 22:42.
To Next Page
