Suzuki GSR600 - Page 70

3-18 ENGINE
• Remove the clutch push rod 8.
NOTE:
If it is difficult to pull out the push rod
8 , use a magnetic hand or
a wire.
• Unlock the clutch sleeve hub nut.
• Hold the clutch sleeve hub with the special tool.
 09920-53740: Clutch sleeve hub holder
• Remove the clutch sleeve hub nut.
• Remove the concaved washer 9, washer 0 and clutch
sleeve hub A.
• Remove the washer B, spacer C and bearing D.
• Remove the primary driven gear assembly E.