5-7
To install a spark plug, turn it in as far
as possible with your fingers, then
tighten it with a wrench.
SPARK PLUG REMOVAL
1. Remove the seat by referring to
the SEAT LOCK section.
2. Remove the 4 fasteners 1, right
and left.
3. Remove the fasteners 2 and
cover 3.
CAUTION
Improper installation of the spark
plug can damage your ATV.
An overly tight or cross threaded
plug will damage the aluminum
threads of the cylinder head.
Carefully turn the spark plug by
hand into the threads. If the spark
plug is new, tighten it with a
wrench about 1/2 turn past finger
tight. If you are reusing the old
spark plug, tighten it with a
wrench about 1/8 turn past finger
tight.
CAUTION
Dirt can damage your ATV if it
enters an open spark plug hole.
Dirt can damage engine parts that
move.
Cover the spark plug hole while
the spark plug is out of the hole.
To Next Page
Loading...
