CHASSIS 5-43
• Install the rear axle housing seals with the special tool.
\ 09913-70210: Bearing installer
• When installing the rear brake anchor pin, apply THREAD
LOCK “1322” to the mating surface of the pin and the axle
housing.
• Apply a small quantity of THREAD LOCK SUPER “1322” to
the anchor pin nut.
H99000-32110: THREAD LOCK SUPER “1322”
REAR BRAKE
• Apply SUZUKI SUPER GREASE “A” to the rear brake cam-
shaft and O-rings.
X
99000-25010: SUZUKI SUPER GREASE “A” or equivalent
• Install the O-rings into the brake camshaft hole.
NOTE:
Face the groove on the camshaft to the inside.
The removed O-rings must be replaced with new ones.
PartShark.com
877-999-5686
To Next Page
Loading...
