Suzuki LT-Z90 - Generator

ENGINE 3-37
STARTER DRIVEN GEAR BEARING INSTALLATION
• Install the bearing with the special tool.
\ 09913-70210: Bearing installer set (¬30)

NOTE:
The stamped mark on the bearing must face crankcase side.
GENERATOR
INSPECTION (6-9)
DISASSEMBLY
• Remove the generator coil
1
, CKP sensor
2
, grommet
3
.
REASSEMBLY
• When replacing the generator coil or CKP sensor, route the
wire properly.
• Apply a small quantity of THREAD LOCK SUPER “1322” to
the CKP sensor mounting bolts
1
and tighten them securely.
H99000-32080: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
" CKP sensor mounting bolts: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
• Apply a small quantity of THREAD LOCK SUPER “1322” to
the generator coil mounting bolts
2
, and tighten them
securely.
H99000-32080: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
" Generator coil mounting bolts:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
The removed bearing must be replaced with a new
one.
PartShark.com
877-999-5686