Suzuki LT-Z90 - Page 190

5-50 CHASSIS
• Remove the bearing with the special tool.
\ 09921-20240: Bearing remover set
SWINGARM PIVOT SHAFT
Check the pivot shaft for runout with a dial gauge and replace it
if the runout exceeds the limit.
\ 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
 Swingarm pivot shaft rumout:
Service Limit: 0.6 mm (0.02 in)
SWINGARM
Inspect the swingarm for distortion or damage. If any defects are
found, replace the swingarm with a new one.
• Remove the dust cover
1
.
• Remove the oil seal
2
.
PartShark.com
877-999-5686