©2018 SwellPro All Rights Reserved
40
Power Selection
1. To enter the power-switching mode, long press the button for 5 seconds, the system will
then display the currently selected power level, corresponding to the number of slow flashes.
If you need to change the power level, press the button to select the desired transmission
power level.
2. After selecting the required power level, press the button for 2 seconds, the dot at the
lower right corner will flash once, confirming your selection, and then exit from the power
selection mode. Release the button, the system will now confirm your selections of the band,
channel and power level, firstly showing you the selected band, followed by the selected
channel, and finally the transmission power level, represented by the number of flashes of the
red dot.
3. Please note: We recommend running at 400mW video power level when operating within
an 800 metre radius, this level is a good nominal level and also extends the flying time. If it is
required to fly in areas of obstructions and/or exceeding 800m, it may be required to switch
to 600mW transmission power.
To Next Page
Loading...
