EasyManua.ls Logo

SWELLPRO SplashDrone4 - Battery Maintenance; Battery Disposal; Pre-Flight Inspection and Checks; Flying Guide

SWELLPRO SplashDrone4
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©2021 Swellpro Technology Co., Limited 47
Keep the battery in a dry and ventilated environment
Never drop the battery into water, or store it in places where there is a possibility of water leakage.
Do not drop, strike, impale, pierce, or manually short-circuit the battery.
Keep the battery away from metal objects, such as watches, jewelry, and hairpins.
Never transport a damaged battery, or a battery with power level higher than 50%.
Do discharge the power to 50% or less before transportation.(The suggested battery voltage level of
the drone is around 15.8V, and the radio controller is 7.9V)
Do discharge the power to 50% or less when you are not going to use the drone in the coming days.
Battery Maintenance
Never use the battery when the temperature is too high or too low.
Never store the battery in environments with a temperature higher than 60°C .
Do discharge the power to 50% or less when you are not going to use the drone in the coming days.
Never store the battery for a long time after use. If need to store for long time, need to fully charge the
battery and then discharge to less than 50% every one month. Otherwise the battery will become over-
discharged, and ruin the battery.
Never over dis-charge the battery, otherwise the battery cells will be damaged.
Do not charge battery immediately after flight, because the battery temperature may be too high.
Battery Disposal
Dispose of the battery in specific recycling boxes only after a complete discharge.
DO NOT place the battery in regular trash containers. Strictly follow your local regulations regarding the
disposal and recycling of batteries.
Pre-Flight Inspection and Checks
Make sure all batteries are fully charged.
Check all propellers are in good condition and correctly fastened. The edges of the propeller blades
must be smooth and undamaged.
Manually rotate the 4 motors to ensure they can spin smoothly.
Ensure the sealing surfaces of the cover are clean, free of dirt, sand, or any other contaminants.
When the drone is flying in the water and landing to replace the battery, please wipe the battery cover
and the surrounding water droplets first. Avoid dripping into the engine compartment when opening
the battery cover and causing damage to the product
Flying Guide
Many regulations require the pilot to fly a drone within line of sight. Take particular care when flying a
drone out of sight.
Unless it is an emergency, NEVER Lock or STOP the motors in flight as this will cause the drone to fall
to the ground and crash.
When the low battery level warning is activated, plan to return the drone and land safely before the
battery reaches a critical level.

Table of Contents

Related product manuals