36
37
ENGLISH
Make sure that the o-ring is intact and positioned
correctly.
TIP: TIP: potentially grease the o-ring with honey so it sits
tightly before you close the pump housing.
Make sure the handmountable nuts are tightened and
tightened evenly so the pump housing is not mounted
skewed. The DANA api MATIC 1000 pump housing only
has two nuts, but the procedure is the same.
O-RING IN THE PUMP HOUSING
The hose is pushed over the tting up to the bending.
Remember to put the hose clamp on before! It is tightened
directly behind the bulge. TIP: Put the hose in warm water for
half a minute. Check if the hose has been mounted correctly.
Here you can see how the hose clamp should be
placed behindthe bulge.
Here you can see how the hose should not be mounted.
The hose clamp is mounted on the wrong side of the
bulge.
It is important that the hose is pushed over the bulge
(red arrow) and that the hose clamp is also placed on
the other side of the bulge.
AIR IN THE HONEY
To Next Page
Loading...
