88
FITTED EQUIPEMNT
Regulating the grill flame
• The grill is to be used only at its rated thermal
capacity.
Visual inspection of the flame
Depending on the type of gas used, the flame
appears as follows:
• Propane (G31): flame with blue internal pin
point and clear outline.
• Butane (G30): flame with slight yellow tips
when igniting the burner; these tips intensify
as the burner heats.
Accessories
Rotating plate
Position the drip tray with the rotating plate as
illustrated in Fig.4. Press the purpose button to
turn on rotating plate motor.
Gas cylinders
CAUTION: The use of gas and/or a pressure
different from those indicated by the
manufacturer could cause irregular and
incorrect operation of the appliance. The
manufacturer declines all liability for the
incorrect or improper use of the appliance.
The gas cylinders to be used are the most
common in the country where the appliance is
used. The gas to be used is clearly indicated on
the outside of the packaging and on the indelible
label attached on the back of the appliance. In
any case, observe the following: Gas cylinders
with valve and pressure reducer must be placed
in an upright position and in the appropriate
compartment, and access should not be
impeded. Replacement of the cylinders must be
performed without impediment and with ease.
Replacing the gas cylinder
• Close the taps of the appliance.
• Make sure no flames or fire are nearby.
• Close the valve of the cylinder to be replaced.
• Unscrew the pressure reducer of the empty
cylinder, take it out of the compartment.
• Proceed in reverse order for replacement.
• Check for gas leaks with the use of a non-
corrosive fluid.
CAUTION:
• Do not use a soap and water solution.
• Do not use an open flame.
• Turn on the burners and check for proper
operation, otherwise contact
an authorised technician.
CLOSE THE CYLINDER GAS SUPPLY AFTER
USE.
Gas leaks
We recommend using a certified electronic gas
leak detector.
If you smell gas:
• Open the windows and immediately get all
people out of the camper, caravan etc.
• Never touch electrical switches, light matches
or do anything that could ignite the gas.
• Extinguish any open flame.
• Close the cylinder valve or gas tank, and do
not open the valve until the gas leak has been
detected and eliminated.
• Contact an authorised technician.
Cleaning and maintenance
Cleaning the appliance
CAUTION: Before cleaning, switch off the
appliance, disconnect it from the mains power
supply and wait for it to cool down.
Note: Hot surfaces could be damaged if they
come into contact with cold water or a damp
cloth.
Do not use abrasive, corrosive, chlorine-based
products, scourers or steel wool.
Do not leave acid or alkaline substances
(vinegar, salt, lemon juice, etc.) on appliance
surfaces.
For stainless steel surfaces and enamelled
parts: wash with soap and water or mild
detergent, rinse and dry. Use clean sponges
and cloths.
To Next Page
Loading...
