Fitted Equipment
SWITCHING ON THE REFRIGERATOR
(control panel)
• It is recommended to clean the inside of
the refrigerator before you switch it on.
• Let the refrigerator cool for at least eight
hours before you place food in it for the
first time.
Igniting and starting your refrigerator
Manual ignition:
Electric ignition:
A. The refrigerator can be powered by the
mains (230V), direct current (12V) or liquid
gas. Select the energy source that you
want by means of the energy source
selector switch (A). The switch has four
settings:
- direct current (DC) (12V)
- mains supply (230V)
- gas
- switched off
B. The thermostat controls the refrigerator
temperature when the refrigerator is
powered from the mains (230 V) or gas.
The refrigeration level is indicated by the
dots (the bigger the dot, the colder the
setting).
C. The flame meter shows whether the flame
is alight. The flame is alight when the red
needle of the meter moves into the green
area.
D. Pressing the manual (piezoelectric) starter
produces a spark that ignites the flame in
the burner.
Electrical operation
The refrigerator can be powered by
electricity in two ways:
• DC (12V): Set the energy source selector
switch (A) to the refrigerator will now
be powered by the battery of your car or
camper.
Important! - Always use the gas connection
or mains voltage to start up the refrigerator
for the first time and to cool it. Powering from
the battery of your vehicle is suitable only for
maintaining the temperature of the
refrigerator and its contents once it has been
refrigerated.
• When powered by a vehicle battery (12 V)
the refrigerator works without temperature
control (i.e. constant operation).
• Mains voltage (230 V): set the power
selector switch (A) to
• Set the temperature by means of the
thermostat, rotary switch (B). (The bigger
the dot, the colder the setting).
Powering with gas
Warning! - Flammable material must be kept
away from the refrigerator.
• For selection of gas type, see the
information plate inside your refrigerator.
• For the pressure regulator model, see the
information plate inside your refrigerator
and the table at the end of this booklet.
• The type of gas container and its location
must be in compliance with the most
recent regulations. Ensure that the unit is
installed in a location with good ventilation
and make sure that the ventilation
openings in the gas container storage
location remain open.
97
A = Energy source selector switch
B = Thermostat
C = Flame meter
A = Energy source selector switch
B = Thermostat
C = Flame meter
D = Manual ignition (piezo electric ignition)
To Next Page
Loading...
Need help?
General
