Fitted Equipment
98
• The changing of the gas container must
be done outside in the open air and out of
reach of any possible sources of ignition.
• You are strongly advised not to use gas to
power the refrigerator while you are
driving. If a road accident results in fire,
there is a danger of explosion.
• You are strongly advised not to use gas to
power the refrigerator in the vicinity of
petrol stations.
1. Open the valve of the gas bottle and the
gas taps.
2. Set the thermostat (B) to the highest level
(the biggest dot)
3. Set the energy source selector switch (A)
to
4. Ignite the gas flame:
Manual ignition (N80P, N90P, N100P,
N112P)
• Press the thermostat (B), and keep it
depressed.
• Press the button for manual ignition
several times at intervals of between 1
and 2 seconds.
• Release the thermostat when the indicator
of the flame meter enters the green area.
If it does not enter the green area, repeat
the previous step.
Warning! Never keep the thermostat
depressed for longer than 30 seconds. If a
flame does not appear, wait at least five
minutes before trying again. If you fail to
observe this rule, there may be an
accumulation of gas creating the risk of fire
or explosion.
• Set the desired refrigeration level by
means of the thermostat (B). (The bigger
the dot, the colder the setting)
Electrical ignition (N80E, N90E, N100E,
N109, N110E, N145E)
• Press the thermostat (B) and keep it
depressed.
• Ignition takes place automatically. You will
hear a ticking noise. If ignition was
successful, the noise will stop and the
flame meter will turn green. Release the
thermostat.
• If the flame goes out, ignition will be
repeated automatically.
• Set the desired refrigeration level by
means of the thermostat (B). (The bigger
the dot, the colder the setting)
Switching off the refrigerator
• Set the energy source selector switch (A)
to
• The refrigerator is now completely
switched off.
• Use the special storage latch on the door
locking mechanism to stop the door from
closing. This prevents unpleasant odours
and mould in the refrigerator.
Important! If you are not going to use the
refrigerator for a prolonged period, close the
valve of the gas bottle and the gas taps.
Electrical ignition (N145E).
• Press the thermostat (B) and keep it
depressed.
• Ignition takes place automatically. You will
hear a ticking noise. If ignition was
successful, the noise will stop and the
flame meter will turn green.
Release the thermostat.
• If the flame goes out, ignition will be
repeated automatically.
• Set the desired refrigeration level by
means of the thermostat (B). (The bigger
the dot, the colder the setting).
Switching off the refrigerator
• Set the energy source selector switch (A)
to
• Use the special storage latch on the door
locking mechanism to stop the door from
closing. This prevents unpleasant odours
and mould in the refrigerator.
Important! If you are not going to use the
refrigerator for a prolonged period, close the
valve of the gas bottle and the gas taps.
To Next Page
Loading...
Need help?
General
