Fitted Equipment
SWITCHING ON THE REFRIGERATOR
(control panel)
• It is recommendable to clean the inside of
the refrigerator before you switch on the
refrigerator.
• Let the refrigerator run for at least eight
hours before you place food in it for the
first time.
Smart Energy Selection (SES)
When you start up a refrigerator equipped
with Smart Energy Selection (SES) you
should usually select the AUTO mode. The
SES system will then automatically select the
best of the three available energy sources.
The system will apply the following priority:
- mains voltage (230V)
- direct current (12V)
- liquid gas
If an energy source becomes available that
has a higher priority than the source the
refrigerator is currently using (e.g. if your
vehicle engine is started), the system will
stop using the current energy source and
switch to the energy source with the higher
priority.
If a fault occurs in one or more of the
possible energy sources, the system will not
generate an error message while an
alternative energy source is still available.
The SES system switches over automatically.
If none of the energy sources is available,
the LED of the main switch will turn from
green to red and flash every second.
SES models additionally allow you to select
the desired energy source manually.
Switching on the refrigerator
Important! The memory of the SES system
saves every change made to the setting.
Consequently, the SES system will start up
on each subsequent occasion in the last-
selected setting.
1. Open the valve of the gas bottle.
2. Open the taps of the gas supply.
3. Press main switch (A). The LED alongside
the main switch will turn green.
4. Use the mode selection switch to select
the "Auto" function or one of the power
supplies that you want. The LEDs will
show the option you have selected.
5. Set the desired cooling level by means of
the cooling level selection switch (C). The
LEDs will show the cooling level setting
you have selected.
A. Use the main switch to switch the
refrigerator on and off. The LED alongside
the main switch will turn green. The
display LEDs show the most recent
settings. After 10 seconds the display
LEDs will go out. The LED of the main
switch remains green.
B. Press the mode selector switch and the
display LEDs will show the setting for 10
seconds. Successively pressing the mode
selector switch takes you through the
menu in the following sequence: AUTO,
manual DC (12V), manual gas, manual
mains voltage (230V) and back to AUTO.
Select either the AUTO option or one of
the other power supplies that you want to
use. The LEDs show the option you have
selected. If you select the AUTO option,
the system will choose the most suitable
power supply and the AUTO LED and the
LED of the power supply chosen by the
system will both light up. Ten seconds
after release of the mode selector switch,
the system will switch off the LEDs. They
will go out.
C. Use the cooling level selector switch to
control the temperature of the refrigerator.
When you press the cooling level selector
switch, the LED showing the currently set
temperature will light up. Every time you
press the cooling level selector switch you
set the refrigerator one position cooler.
99
A = Main switch (on/off)
B = Mode selection switch
C = cooling level switch
D = Display LED
To Next Page
Loading...
Need help?
General
