Fitted Equipment
100
On reaching the coldest temperature, the
system will start again at the warmest
temperature setting. Ten seconds after
release of the cooling level selector
switch, the system will switch off the
LEDs. They will go out.
Powering with electricity
Powering with electricity can be selected
both by the Auto mode and manually.
Auto mode
Mains voltage (230V):
This energy source will be selected if the
mains voltage is greater than 200V. This
power supply requires a continuous current
of 12V to operate the electronic control
system.
Direct current (12V) :
The SES system will select 12V powering
only if a mains voltage (230V) is unavailable,
the vehicle engine is running and a voltage
higher than 11V is available.
If a fault occurs during electrical powering
(230V or 12V), an error message will not be
shown on the display as long as another
energy source is available. The system will
automatically switch to the available energy
source that has the highest priority.
Selecting electrical power manually
Mains voltage (230V):
The LED on the main switch warns you
whenever insufficient voltage is available
or if a fault occurs. If this happens, the
LED will change from green to red and
flash once per second.
When sufficient current is available again, or
the fault has been resolved, the main switch
LED will emit a steady green light again.
Direct current (12V):
The main switch LED warns you whenever
your vehicle's engine is not running, or if a
fault occurs, or if insufficient voltage is
available. If this happens, the LED will
change from green to red and flash once
per second.
Once the engine is running, or the fault has
been resolved, or sufficient voltage is
available again, the main switch LED will
again emit a steady green light.
NB: If the refrigerator has been manually set
to operate at 12V, it will not automatically
switch to another energy source when your
vehicle's engine is not running. In this case,
the refrigerator will stop cooling.
Powering with gas
Powering with gas can be selected both by
the Auto mode and manually.
Warning! - Flammable material must be kept
away from the refrigerator.
• For selection of gas type, see the
information plate inside your refrigerator.
• For the pressure regulator model, see the
information plate inside your refrigerator
and the table at the back of this booklet.
• The type of gas container and its location
must be in compliance with the most
recent regulations. Ensure that the unit is
installed in a location with good
ventilation and make sure that the
ventilation openings in the gas container
storage location remain open.
• The changing of the gas container must
be done outside in the open air and out
of reach of any possible sources of
ignition.
• It is prohibited to use gas to power the
refrigerator while you are driving. If a road
accident results in fire, there is a danger
of explosion.
• It is prohibited to use gas to power the
refrigerator in the vicinity of petrol
stations.
To Next Page
Loading...
Need help?
General
