Fitted Equipment
Auto mode
The system will select gas operation if:
- mains voltage (230V) is unavailable;
- the vehicle's engine is not running.
Once mains voltage (230V) is available again
or the vehicle's engine is running, the system
will switch to the available energy source that
has the highest priority. If the refrigerator
switches from 12V DC to gas operation when
it is in auto mode, the system will wait for
about 15 minutes before igniting the gas.
During this time, however, the gas indicator
lamp will come on. The delay is built in to
avoid it switching to gas operation whenever
you stop to refuel your vehicle. You can
cancel the delay by immediately switching
the refrigerator off and then on again. If the
system selects gas operation, the ignition will
be activated automatically. The gas will flow
to the burner and be lit by the electric
ignition. If the flame goes out, the gas will
immediately be lit again.
Selecting gas operation manually
If the flame cannot be lit within 30
seconds, the gas supply will stop and gas
mode will be switched off. The LED of the
main switch will turn from green to red
and flash every second.
The gas mode can be reset only if the
refrigerator is switched off. If you switch the
101
refrigerator on again and the gas mode is still
not working, the LED of the manual gas
mode will flash to indicate that gas is
unavailable.
Important! It is prohibited to use gas to
power the refrigerator while you are driving. If
a road accident results in a fire, there is a
danger of explosion. It is prohibited to use
gas to power the refrigerator in the vicinity of
petrol stations. If it takes longer than 15
minutes to refuel your vehicle, you should
switch the refrigerator off using the main
switch (A).
Switching off the refrigerator
• Set the main switch (A) to 0 (off).
• The refrigerator is now completely
switched off.
• Use the special storage latch on the door
locking mechanism to stop the door from
closing. This prevents unpleasant odours
and mould in the refrigerator.
SWITCHING ON THE REFRIGERATOR
(control panel)
• It is recommendable to clean the inside of
refrigerator before you switch on the
refrigerator
• Let the refrigerator run for at least eight
hours before you place food in it for the
first time.
Smart Energy Selection (SES)
When you start up the refrigerator (equipped
with Smart Energy Selection (SES)) you
should usually select the AUTO mode. The
SES system will then automatically select the
best of the three available energy sources.
The system will apply the following priority:
- mains voltage (230V)
- direct current (12V)
- liquid gas
If an energy source becomes available that
has a higher priority than the source the
refrigerator is currently using (e.g. if your
vehicle engine is started), the system will
stop using the current energy source and
switch to the energy source with the higher
priority.
If a fault occurs in one or more of the
possible energy sources, the system will not
generate an error message while an
alternative energy source is still available. The
SES system switches over automatically.
If none of the energy sources are
available, the blue LED flashes every
second and an error code is shown in the
display.
Automatic models additionally allow you to
select the desired energy source manually.
To Next Page
Loading...
Need help?
General
