Fitted Equipment
85
Dometic Service department. Your Service
Centre contact numbers numbers are found
in the "European Service Network" booklet
When contacting Dometic Service, please
state the model, product number and serial
number together with the MLC Code, if
applicable. You will find this information on
the data plate inside the refrigerator.
DESCRIPTION OF MODEL
Refrigerator Mobile /
Mobile Absorption Refrigerator
"L" with interior light
RM 7291 L
Last digit 1 = manual energy selection
Last digit 5 = automatic and manual
energy selection
CLEANING
Before using the refrigerator, it is advisable
to clean the appliance both inside and out.
• Use a soft cloth and lukewarm water with
a mild detergent.
• Then rinse the appliance with clean water
and dry thoroughly.
• Remove dust from the refrigerator unit at
yearly intervals using a brush or soft
cloth.
Warning: To avoid deterioration of
materials:
• Do not use soap or hard, abrasive or
soda-based cleaning agents.
• Do not allow the door seal to come
into contact with oil or grease.
Using the refrigerator
• The cooling unit is silent in operation.
• When the appliance is first put into
operation, there may be a mild odour
which will disappear after a few hours.
• Ensure the living area is well ventilated.
• The refrigerator will take several hours to
reach its operating temperature in the
cooling compartment
• The freezer compartment should be cold
about one hour after switching on the
refrigerator.
Controls
A. Manual energy selection MES (e.g. RM
7XX1 L)
B. Automatic and manual energy selection
AES ( e.g. RM 7XX5 L)
Note: The refrigerator is equipped to operate
on mains power, DC or liquid gas (propane/
butane). The desired power option is
selected by means of energy selector switch
(A). Energy selector switch (A) has four
settings: AC mains power, DC (12V), Gas
(liquid gas), OFF.
Appliances with automatic energy selection
have the additional setting "AUTO" .
A = energy selection switch
B = gas/electric thermostat AC/DC
C = operating displays (3 LEDs)
A = energy selection switch
B = gas/electric thermostat AC/DC
C = operating displays (4 LEDs)
D = temperature setting display
E = dimmer for LED-displays
(only accessible when door opens)
Gas
AC mains power
12V DC
Automatic energy
selection
OFF
To Next Page
Loading...
Need help?
General
