MANUAL ENERGY SELECTION
ELECTRICAL OPERATION
12V - operation (DC)
Warning: The refrigerator should only
be used while the motor is running,
otherwise the on-board-battery would
be discharged within a few hours!
1. Set energy selector switch (A) to 12V .
2. Operating display "C", 12V lights "green".
Appliance is in function.
3. Use rotary switch (B) to regulate the
temperature in the main refrigerator
compartment.
Note: If the operating display fails to light up
( it lights up "red" at AES models ) the device
is not in operation. (For troubleshooting see
page 82).
Mains power
This option should only be selected where
the supply voltage of the connection for
power supply corresponds to the value
specified on the data plate. Any difference in
values may result in damage the appliance.
1. Set energy selector switch (A) to 230V .
2. Operating display "C", 230V lights
"green".
Appliance is in function.
3. Use rotary switch (B) to regulate the
temperature in the main refrigerator
compartment.
Note: If the operating display fails to light up
( it lights up "red" at AES models ) the device
is not in operation. (For troubleshooting see
page 82)
GAS OPERATION
• The refrigerator should only be operated
using liquid gas (propane, butane). Do not
use town gas or natural gas.
• If the refrigerator is operated during travel
using gas, the precautions stipulated by
the legislation in the respective country
must be taken (in conformity with the
European standard EN 732).
• Operating the refrigerator with gas is not
permitted during travel in France and
Australia.
• As a basic rule, operation using gas is
prohibited in petrol stations.
1. Open the valve of the gas cylinder
2. Open the shut-off valve to the gas supply.
Fitted Equipment
86
To Next Page
Loading...
Need help?
General
