16. ELECTRICAL EQUIPMENT SYM
16-16
Starter Motor Removal/Disassembly
Remove body cover.
Remove bolt and oil pump control cable.
Disconnect starter motor harness coupler.
Remove 2 bolts for separation starter motor
and gasket.
Remove 2 bolts for disassembly the starter
motor.
Armature Inspection
Check the armature for discoloration or other
damage. It may be short-circuiting if dark
surface on the shifter found.
Caution
Do not clean the shifter surface with
sandpaper.
Check continuity 1) both the shifter surface and
shaft, 2) among the shifter surfaces. It can be
in continuity among the shifter surfaces, but
both the shifter surface and the shaft cannot be
in continuity.
Starter Motor Re-Assembly/Installation
Re-assemble and install the starter motor in
reverse order of removal procedures.
Starter motor
2 bolts
O-ring
Motor housing
Armature
Carbon bracket
Spring
To Next Page
Loading...
Need help?
General