To Next Page

To Previous Page

○d Coolant Temperature Gauge

This digital coolant temperature gauge displays the temperature of engine coolant. The coolant

temperature varies with changes in the weather and engine load. If the seventh bar ○a goes on, when

the scooter is in operation, stop the engine and move the scooter to a safe place, and check the coolant

level in the reserve tank and the radiator fan (page 12).

○e Multi-function Display

When the ignition switch is turned on, battery voltage will display for approximately 10 seconds. Then the

below display mode can be shifted circularly by pushing the S button.

Push M button to switch the below display mode:

Clock

This clock displays only 24-hour mode.

To set the clock, do the below steps:

 Turn the ignition switch on and wait for approximately 10 seconds until the clock displays.

 Push the M button for more than 2 seconds, the hour display starts blinking. Push the S button to adjust

the hours.

NOTE :

 This scooter is not equipped with a high coolant temperature indicator.

 The coolant temperature gauge will not blink when the coolant temperature is too high.

 Please take notice of the coolant temperature gauge when the engine is running.

NOTE :

 The multi-function display always shows the previous selected mode every time you turn the ignition

switch on.

 The multi-function display shows in odometer mode after the battery is reconnected.

○a

Questions and Answers:

Need help?

Do you have a question about the Sym MAXSYM 400 and is the answer not in the manual?

Sym MAXSYM 400 Specifications

General