To Next Page

To Previous Page

 Push the M button. The hour display stops blinking and the minute display starts blinking. Push the S

button to adjust the tens place in the minute display.

Push the M button. The tens place stops blinking and the units display starts blinking. Push the S button

to adjust the units place in the minute display.

 Push M button to finish clock setting.

Battery Voltage Gauge

The battery voltage display shows current battery voltage. It is forced display approximately 10 seconds

when the ignition switch is turned on.

 Display range: 9~18 V.

Odometer

This odometer shows the total distance in kilometers the scooter has been ridden. It cannot be reset.

NOTE :

 When the battery is disconnected, the clock is reset to 12:00 and starts working again when the battery is

reconnected.

 If the clock is idled about 30 seconds while setting, it will exit setting mode automatically and starts

working again.

 The clock setting will be finished when the clock is idled about 30 seconds while setting the minute

display.

 If the ignition switch is turned off while setting the clock, the clock will exit setting mode when the ignition

switch is turned on again.

 The clock works normally by the backup power even the ignition switch is turned off.

NOTE :

 The data is maintained in the combination instrument even when the battery is disconnected.

 When the figures come to 99999, they will return to 0 and the odometer starts working again.

 This odometer only shows in kilometers.

Questions and Answers:

Need help?

Do you have a question about the Sym MAXSYM 400 and is the answer not in the manual?

Sym MAXSYM 400 Specifications

General