Sym MAXSYM 400i - Maintenance Information; Precautions in Operation; Periodical Maintenance Schedule; Engine Oil

2. Maintenance Information
2-1
Precautions in Operation ················· 2-1
Periodical Maintenance Schedule ····· 2-2
Engine Oil ······································ 2-3
Engine Oil Strainer Clean ················ 2-3
Gear Oil ········································· 2-4
Fuel Lines / Cable ··························· 2-4
Air Cleaner ···································· 2-5
P.C.V. System ································ 2-6
Valve Clearance ····························· 2-6
Spark Plug ····································· 2-7
Cylinder Compression Pressure ······ 2-8
Drive Belt ······································ 2-8
Steering Handle Top Bearing ··········· 2-9
Cushion········································· 2-9
Disk Brake System ························· 2-10
Brake Light Switch / Start Switch ····· 2-12
Wheel / Tire ···································· 2-12
Battery ·········································· 2-13
Nuts, Bolts Tightness ····················· 2-13
Special Tools List ··························· 2-14
Precautions in Operation
Model
LX40A
LX60A
Fuel Tank Capacity
14.2 ± 0.5 L
Engine Oil
capacity
2,000 c.c.
2,300 c.c.
change (with oil filter
replaced)
1,900 c.c.
2,000 c.c.
change
1,800 c.c.
1,900 c.c.
Transmission
Gear oil
capacity
350 c.c.
change
330 c.c.
Capacity of
coolant
Engine + radiator
1,500 c.c.
Reservoir upper
350 c.c.
Clearance of throttle valve
2~6 mm
Spark plug
CR8E (gap:0.6~0.7 mm)
Timing advance idle speed
BTDC 10º / 1,550 rpm
BTDC 13º / 1,550 rpm
Idling speed
1,550±100 rpm
Cylinder compression pressure
12.5 ± 2 kgf/cm²
Valve clearance
IN
0.10±0.02 mm
EX
0.15±0.02 mm
Tire dimension
Front
120/70-15 56S
Tire dimension
Rear
160/60-14 65H
Tire pressure
(cold)
single
Front: 2.00 kg/cm² Rear: 2.30 kg/cm²
Load 90 Kg (full load)
Front: 2.00 kg/cm² Rear: 2.50 kg/cm²
Battery
12V11.2Ah (MF battery) / TTZ14S
Home page
Contents
2