13
Ⓔ Hazard Switch
Turn on the hazard switch, all the turn signal lights and turn signal indicators will blink.
At this time, turning main switch to OFF position cannot cancel the hazard function, and it
will keep consuming battery power. Please do not use for a long period, or the engine
probably cannot be started. To turn off the hazard function, the main switch has to be
turned to “ON” position.
Ⓕ Idling Start & Stop Switch
Turn the Idling Start & Stop Switch to “ ” position to activate the Idling Start & Stop mode.
Turn the switch to “OFF” position to exit.
Ⓖ Starter Button
For electrical starting the engine, please push the starter button.
Turn the ignition switch on; push this button while holding the front or rear brake lever to start
the engine.
USB Charge Unit (with blue LED )
• Rated voltage: Main switch “ON”, DC 12V input
• Voltage usage range: 10.5V~16V
• Output voltage: DC3.6V~12V±10%V，blue LED on
• Output ampere: 3.0±10%A , 2.0A±10% A, 1.5A±10% A, auto shift
• Fast charge support BC1.2, QC2.0/3.0, auto shift
• Overload protection: Over 3.3A, blue LED off
• Overheat protection: Output cut off when temperature
is above 135°C; output recover when temperature at 100°C.
• USB waterproof cover: USB socket has to be kept clean and dry. The USB waterproof cover
can help prevent dust from getting in and reduce oxidization of the socket.
Front Compartment
• Do not overload the front compartment to avoid
affecting handlebar operation.
• When washing your scooter, remove your valuables
from front compartment to avoid damage.
Fuel Tank Cap
Insert ignition key to main switch and turn
counterclockwise to open the fuel tank cap.
After refilling fuel, press close the cap until “click” sounds.
WARNING
It is suggest not to use the hazard function under Idling Start & Stop mode. If hazard function
and Idling Start & Stop are activated at the same time, it is possible to dry out battery power.
WARNING
• To avoid engine damage, do not push the starter button after the engine is started.
• For safety reason, the brake has to be applied for electrical starting.
unit
cover
To Next Page