SYMA Z3 - Drone Specifications and Troubleshooting; Key Drone Technical Specifications; Common Drone Problem Solutions

-15 -
Problem Reason Solution
Main Specifications
Drone’s Length: 320mm Drone’s Width : 320mm
Drone’s Height: 50mm Motor’s Model : Ø8x16
Battery : 3.7V 500mAh lithium battery
Rectification Procedures
The drone
has no
response
1. The drone has entered into
low-voltage protection.
2. When the power of the remote
control is weak,the power light
indicator will blink.
1. Charge up the drone.
2. Change the batteries of
the remote control.
The flight
response of
the drone is
not sensitive
1. The power of the remote control
is weak.
2. There is an interference with
the same frequency as that of
the remote control.
1. Change the batteries.
2. Change to a place where there
is no interference with the same
frequency.
The drone is
flying towards
its side in one
direction during
hovering
1. The drone is not calibrated
level to the ground.
1. Re-adjust the calibration until
the drone is level to the ground.
For further details, see No.3 on
Page 8 for details(Level
calibration function).
In the headless
state, it is biased
towards the front
direction
1. Many collisions may cause
head drift.
Fixed high
instability / up
and down
movement
1. Re-define the front direction.
For further details, see No. 8
Page 9 for details(Headless
function).
1.The drone is not calibrated
level to the ground.
2.Unstable air pressure under
the severe weather condition.
3. Violent collision resulting in
data disorder of gyroscope.
1.Re-adjust the calibration until
the drone is level to the ground.
For further details, see No.3 on
Page 8 for details(Level
calibration function).
2. Avoid to fly under the severe
weather condition.
3. Make level adjustment again,
see No.3 on Page 8 for details
(Level calibration function).
320mm
320mm
320mm
50mm