5-93
Parameter Menus
Intercharacter Delay
Select the intercharacter delay option matching host requirements. The intercharacter
delay gives the host system time to service its receiver and perform other tasks between
characters. The delay period can range from no delay to 99 ms in 1 ms increments (if you
are using a cradle and RTS/CTS handshaking, the delay period can range from 5 ms to 99
ms). After scanning the bar code below, scan two bar codes beginning on page 5-101 to
set the desired time-out. If you make an error, or wish to change your selection, scan
CANCEL on page 5-103.
INTERCHARACTER DELAY
MCL-Net Parameters
MCL-Net Baud Rate
Baud rate is the number of bits of data transmitted per second. Scan the appropriate bar
code below to set the MCL-Net baud rate. The default baud rate is 38400.
BAUD RATE 600
To Next Page
Loading...
