5-22
P470/370 RF Scanner Product Reference Guide
Laser On Time
This parameter sets the maximum time decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
Scan the bar code below to set a Laser On Time. Next scan two numeric bar codes
beginning on page 5-101 that correspond to the desired time. Time less than 1.0 second
must have a leading zero. For example, to set a Time On of 0.5 seconds, scan the bar
code below, then scan the “0” and “5” bar codes. If you make an error, or wish to change
your selection, scan CANCEL on page 5-103.
Note:Allowing the scanner to stay on longer than originally programmed
may affect the battery life time for that session before needing a
charge.
LASER ON TIME
To Next Page
Loading...
