5-8
P470/370 RF Scanner Product Reference Guide
Communication Protocol
The bar codes below set the communication protocol used by the Scan & Transmit default
application.
The communication options are RS232/Synapse or MCL-Net. If you select RS232/
Synapse, the scanner automatically identifies whether an RS232 or Synapse interface is
required. MCL-Net allows the scanner to communicate with a host running MCL-Link or
MCL-Link Lite.
Scan & Transmit Application
This communication protocol is used for the real time scanning and transmission of data to
a host when a cable is attached to the cradle.
*RS232/SYNAPSE
MCL-NET
Note:These communication protocol parameters only work with the
default applications and will not work with applications created with
MCL-Designer.
To Next Page
Loading...
