Synel 765 - Page 12

- 11 -
•
Set/Reset/Exit: E
o
Set
 Select S to continue and setup the Wi-Fi settings.
o
Reset
 Use this menu to reset the Wi-Fi card and to change the password.
o
Exit
 Use this menu option to exit out of the Network Connection settings.
•
Polling (Y/N): N
o Option not used, should always be
N
.
•
MAC Send (Y/N): N
o If you want to confirm sending your terminal’s network MAC address to the host. Then after exiting technician mode
the terminal will send the host a “Hardware configuration network” message informing it of its MAC address, IP etc.
•
My IP Address (If Y selected above): ###.###.###.###
o Use the numeric keys to enter the IP Address.
•
Gateway Address: ###.###.###.###
o Use the numeric keys to enter the IP Address.
•
Remote Address: 000.000.000.000
o Always left at all zeros.
•
Subnet Mask: ###.###.###.###
o The subnet mask is the network address plus the bits reserved for identifying the sub-network. Use the numeric
keys to determine the terminal’s subnet mask affiliation within your local net.
•
My Port: 03734
o TCP/IP enables connecting multiple applications via the same address. The port number selected here is the
application identification number used by the computer when communicating with the terminal. TA applications use
the default port number 3734. However, you may change this according to your specific needs.
•
Host Port: 03734
o TA applications use the default port number 3734. However, you may change this according to your specific needs.
Use the numeric keys to change the port number.
•
Disconct Sec: 30
o Disconnect seconds defines the number of waiting seconds before reverting to offline mode.
•
DHCP (Y/N): N
o
Note:
TA applications uses static IP addresses for communication, as this feature is not supported.
•
SSID (service Set Identifier):
o Entered in HEX form. The sequence of characters identifying the wireless local area network, allowing the stations
to connect to a specific network when multiple independent networks operate in the same physical area.
•
Authentication Method:
o Specifies the method of authentication. Set by drilling down and selecting the parameters:
 Open
• WEP – Enter 4 keys
• WEP Key Number – Specify the number of the key in the sequence of 4 keys.
• WEP Key – Enter the key.
• Wi-Fi WEP – choose:
• None
• 64 bit
• 128 bit
•
Shared Key:
o Set by drilling down and selecting the parameters.
 Open
 WEP Key Number – Specify the number of the key on the sequence of 4 keys.
 WEP Key – Enter the key.
 Wi-Fi WEP – choose:
 None
 64 bit
 128 bit
 WEP – Enter 4 keys.
 WEP Key Number – Specify the number of the key on the sequence of 4 keys.
 WEP Key – Enter the key.
 Wi-Fi WEP – choose:
 None
 64 bit
 128 bit
•
WEP (802.1x authorization):
o Set by drilling down and selecting the parameters.