Synesso S Series

21
Steam Tank and Hot Water Tap Connued...
From the picture on the previous page, Line 1 shows the current reading of the steam tank temperature
probe (250.8F in this example). Once this temperature reaches the set point, the digital display will connu-
ously adjust in small increments as the electronics balance the temperature.
Line 2 is indicang the set point of 250.0F (121.1C). The adjustable set range for the steam tank is between
200F and 265F (93.3C and 129.4C).
Line 3 is showing the hot water tap run me. To avoid excess water use, set this as low as you can.
To cycle to the next display screen, press the down buon.
PROGRAMMING
Line 2 indicates the adjustable amount of me that the purge will run before shung o. This seng is used
for all purge buons.
To cycle to the next display screen, press the down buon.
Menu Level 1: Purge Buon Time
Menu Level 1: Auto Backush
Auto backush can be acvated by pressing the line buon associated with the group you want to ush. Set
the value to “ready”, then place a portalter equipped with a blind basket into the selected brew group. Shi
le on the group head. The selected group will run the brew valve and motor for 10 seconds, followed by 10
seconds o. This will repeat 5 mes. The shot mer will count up to 10 to let you know when it is running.
Upon compleon, the mer will read 10. Remove the portalter and thoroughly clean the diuser screen.
Please connue to the next page for more details.