Installation |
15
Test the motor windings:
♦ Measure the insulation resistance of each motor winding against grounding at 500 V DC. The insulation resistance
must be > 10 mΩ.
Measures for an insulation resistance < 10 mΩ:
1. If the motor has drain plugs, remove them to allow any moisture to drain and replace them when the motor windings
are suitably dry.
2. Dry the motor in a warm dry airflow (typically 40 degrees Celsius).
3. Measure the insulation resistance of each motor winding against grouding at 500 V DC.
4. Repeat the aforementioned steps until the measurement outcome > 10 mΩ.
7.4 Tightening torques of screw-type connections according to DIN 13
Table 14 Tightening torques according to DIN 13
Screw size
Key width 6.9 M [Nm] 8.8 M [Nm] 10.9 M [Nm] 12.9 M [Nm] Aluminium hubs [Nm]
M6 10 9 10 15 18 8
M7 11+12 14 17 25 28 14
M8 13+14 22 26 35 42 21
M10 15+17 42 50 71 85 40
M12 19+21 74 87 123 147 70
M14 22+23 117 138 194 235 110
M16 24+26 178 210 299 358 159
M18 27 245 289 412 490 231
M20 30 348 412 579 696 330
M22 32 471 559 785 941 447
M24 36 598 711 1000 1196 569
M27 41 888 1049 1481 1775 839
M30 46 1206 1422 2010 2403 1138
M33 50 1628 1932 2716 3266 1546
M36 55 2099 2481 3491 4197 1985
M39 60 2716 3226 4531 5443 2581
M42 65 3364 3991 5609 6727 3193
7.5 Mounting feet
Depending on the kind of fan and the construction size, mounting feet are either included in the delivery or available as
accessories. If you are not sure, check the online catalogue or contact Systemair.
7.6 Avoid resonance frequencies
Important
Risk of damage to the fan due to resonance frequencies
♦ The minimum fan speed should be double the resonance frequency of the anti-vibration system
(vibration dampers).
♦ To avoid resonance frequencies, see 8.5 Frequency converter (if used), page 22.
7.7 Vibration dampers
Important
Risk of damage to the fan due to incorrect vibration dampers
♦ Use the vibration dampers suitable for the respective weight.
♦ Use the vibration dampers with fire resistance classes that match the respective application.
| 004