1. 40 feet (12 meters)
2. 5 feet (1.5 meters)
3. 10 feet (3 meters)
4. 25 feet (7.6 meters)
5. Dryer
6. Do not install the product.
7. If product is installed, install a secondary lint trap between the dryer and the product.
8. If product is installed, Fantech recommends to install a secondary lint trap.
9. Do not install the product.
3.2 To Install the Product
3.2.1 To Mount the Bracket
Caution
Using the wrong length screws will damage
the motor impeller.
1 For correct operation, position the control box (located on
the product) to provide access to the indicator panel wiring
and tubing connections.
2 On the opposite end of the control box, position the bracket
onto the product.
3 Make a mark through the middle holes of the bracket onto
the product.
4 Using the marks for guidance, drill two (2) 3/32" (2mm) pi-
lot holes in the product.
5 Using two (2) self tapping 1/2 inch (13mm) screws pro-
vided, attach product to the mounting bracket.
5
To Next Page
Loading...
