SystemAir Fantech DEDPV-705 - To Mount the Product in a Vertical or a Horizontal Position; To Install the Ducts

3.2.2 To Mount the Product in a
Vertical or a Horizontal
Position
3.2.2.1 To Mount the Product in a
Vertical Position
Note:
Vertical mounting is recommended to reduce condensation
buildup in the product.
1 Using two (2) 3/4 inch (19mm) wood screws provided, at-
tach the mounting bracket to a support beam at the se-
lected location.
2
B
3.2.2.2 To Mount the Product in a
Horizontal Position
1 Drill a 1/4 inch (6mm) hole in the bottom of the housing
(along with an NPT insert (provided by others) and drain
tubing) to allow the condensation to drain.
3
C
3.2.3 To Install the Ducts
Note:
The cleanout ducts must be removable for maintenance
work.
1 Position the two (2) 10 inch (254mm) adjoining cleanout
ducts 10–1/8 inches (257mm) away from the product outlet
and inlet.
2 Using two (2) FC Mounting Clamps and the accompanied
hardware, install the two (2) ducts onto the inlet and outlet
of the product.
4
Note:
On both ends of the cleanout ducts, leave 0.06 inches
(1.5mm) of clearance to mate the ducts.
1 Move the two (2) FC Mounting Clamps onto both ends of
the cleanout ducts.
2 Using the accompanied hardware, safety the clamps onto
the ends of both ducts.
5
6