PAGE
Section 4 • Installation Guide
b) If the source is shared by another system,
connect the appropriate S4.3 Controller
source output to the appropriate input of
the main system’s preamplifier, etc.
4.12 Speaker Cable Connections
NOTE: These zone connection
instructions deal with one zone only.
Connections for all other zones are
identical except for the mirror-image
connector placement on alternate zones.
Use the supplied quick-fit terminals for all
speaker cable connections.
Strip back each conductor's outer
insulation by 6mm, insert bare wire into
quick fit plug and secure using the screw
terminal fixing. Take care to ensure
proper polarity (note "+" is normally
identified by a fine rib running along one
edge).
BE CAREFUL AND BE PATIENT. This
is an admittedly tedious task,
particularly when you are hooking
up speakers for all four zones, but it
is essential for maximum system
enjoyment.
“Out of phase” loudspeaker hookups
(where one speaker in a stereo pair is
inadvertently connected “+” to “-” and
vice versa) may not be immediately
noticeable but will not be as pleasing in
the long term as a properly connected
stereo pair.
AUDIO IN
AUDIO
OUT