EasyManua.ls Logo

Systemline S4.3 - 1 Overview; Table of Contents

Default Icon
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PAGE
1 Overview 1
1.1 Basic Architecture 1
1.2 Controlling the Remote Zones 1
1.3 System Flexibility 1
1.4 Systemline Highlights for Installers 1
2 Component Description 3
2.1 S4.3 Controller 3
2.2 RHS IR Remote Control 4
2.3 DMS Module 4
2.4 KMS Keypad 5
2.5 Data Cable and Connectors 5
2.6 Speaker and Cable Connections 5
3 System Planning 6
3.1 Initial Considerations 6
3.2 S4.3 Controller Basic Set-up 7
3.21 Placement 7
3.22 Connections 7
3.23 IR “Flood” Emitter 8
3.24 IR Emitter Jacks & Cabling 8
3.25 N/C Jack 8
3.3 Zone Configuration 9
3.31 Basic Zone Complement 9
3.32 Control Code Generators 9
3.33 Loudspeakers 9
3.34 Zone Splitters 9
3.4 A/V Wiring 10
3.41 Recommended Configuration 10
4 Installation Guide 11
4.1 The S4.3 Controller 11
4.11 Source connections 11
4.12 Speaker Cable Connections 12
4.13 Preamp Outputs 13
4.14 Data Cable Connections 13
4.15 Paging Input 14
4.2 Zone Control Devices 15
4.21 DMS Module 15
4.22 The KMS Keypad 16
4.23 Fitting DMS & KMS Modules 17
4.3 Zone Connection Strategies 19
4.4 Zone Splitter Connection 20
5 System Set-up 21
5.1 A.C. Line Considerations 21
5.11 A.C. for the S4.3 Controller 21
5.12 A.C. for Source Components 21
5.13 Multi-Controller Control Link 21
5.14 External Control of A.C. Mains Outlets 21
5.15 A.C. Power Recommendations 21
5.2 Source Component Setup 21
5.21 Default Operating Mode 22
5.22 Optional Operating Modes 22
5.23 Set-up Sequence 23
5.3 IR System and Control Codes 24
5.31 Overview 24
5.32 Front Panel IR Flood Emitter 25
5.33 Rear Panel IR Emitters 25
5.4 Advanced Multi-Zone Systems 25
5.41 8 - and 12 - Zone Systems 25
5.42 Large System Configuration 25
5.43 Source Connections 26
5.44 IR Flood Emitter Connections 26
5.45 IR Repeater Connections 27
5.46 RC-5 Bus Connection 27
5.47 IsoLink Connection 27
5.48 A.C. Connections 27
5.49 Engaged Operation 27
5.5 Paging Operation 28
5.51 Paging Inhibit 28
5.6 Configuring the Pre-Out Sockets 28
6 Operation 29
6.1 Preliminary Observations 29
6.2 RHS Hand-held Remote Control 29
6.21 Input Selector Buttons 30
6.22 Tuner (Source 1) Control Buttons 30
6.23 CD (Source 2) Control Buttons 30
6.24 Tape/Satellite or Cable (Source 3)
Control Buttons 30
6.25 VCR/DVD/Tuner 2/CD 2 (Source 4)
Control Buttons 31
6.26 VOLUME UP, VOLUME DOWN 31
6.27 MUTE 31
6.28 STBY 32
6.29 “X” 32
6.3 KMS Keypad 32
6.31 Key Functions 32
6.32 System Commands 33
6.33 Tuner (Source 1) Commands 33
6.34 CD (Source 2) Commands 33
6.35 Tape/Satellite or Cable (Source 3)
Commands 33
6.36 VCR/DVD/Tuner 2/CD 2 (Source 4)
Commands 34
6.4 DMS Module 35
6.41 Overview 35
6.42 Controls and Indications 35
6.43 Dot Matrix Display 35
6.44 Operation 36
6.45 Setting Alarms and Time 36
6.46 Zone Splitter Control 37
7 Specification 38
QED Faxback 39
Table of Contents

Table of Contents