10 (36), 0-004-7506-4 (EN) TAC AB, 2001-08-08
TAC Xenta OP Handbook 2 Connection and Basic Functions
COMFORT
ECONOMY
OFF
TAC Xenta 100
Wall Module
Connecting the TAC Xenta OP to TAC Xenta 100 via the Wall Module
2.2 Connecting to TAC Xenta 100
Normally the TAC Xenta OP is connected to the modular jack on the
lower side of the Wall Module. In this way the Xenta OP will get
power supply from the TAC Xenta 100 unit.
Cable between controller and Operator panel...................... max. 10 m
The contrast of the display can be adjusted with the potentiometer on
the rear of the operator panel; please refer to the figure in the next
section.
To Next Page
Loading...
Need help?
General