RWP Weighing Indicator Technical Manual(v1.16)
5. OPERATION
Initial Start – Up:
Warm-up time of 15 minutes stabilizes the measured values after switching on.
Switch on the balance by pressing key.
The display is switched on and the test is started and if want to switched
off, press again the key.
5.2. Zero
Environmental conditions can lead to the balance exactly zero in spite of
the platform not taking any strain. However, you can set the display of
your balance to zero any time by pressing key and therefore
ensure that the weighing starts at zero.
The weight of any container can be tared by pressing button so
that with subsequent weighing the net weight of the object being weighed
is always displayed.
Load weight on the platform.
Press key. Zero is displayed, and tare is subtracted.
Remove weight on the platform. Tared weight is displayed. It can set only
one tare value. It can display with a minus value.
Press G/N to change between gross weight and net weight.
To clear the tare value, remove the load and press key. Zero is
displayed, tare weight is cleared.
5.4. Sample weighing
Place goods to be weighed on the platform.
Wait few seconds for stability display.
Avoid overloading. When display appears “ol” reduce the load or
unload.
5.5. Check Weighing
To Next Page
Loading...
Need help?
General
