TA Instruments Nano ITC Series User Manual

Page 20 Nano ITC Getting Started Guide
Starting the Nano ITC
Once you have completely set up the calorimeter and computer system, you can start the instrument as
follows:
1 Turn on the surge suppressor power switch and the computer system and monitor.
2 Turn on the power switch to the calorimeter, which is located on the back panel. The front LED will
light up green when in the “on” position.
Figure 8 LED location on Nano ITC Low Volume instrument.
3 Start the ITCRun software on the computer. You are now ready to begin preparing to run an experiment.
Power LED light

TA Instruments Nano ITC Series Specifications

General

Brand	TA Instruments
Model	Nano ITC Series
Category	Measuring Instruments
Language	English