Nano ITC Getting Started Guide Page 5
Low Voltage Directive (Safety)
In order to comply with the European Low Voltage Directive (2006/95/EC), this equipment has been
designed to meet IEC 1010-1 (EN 61010-1) standards. To comply with requirements in the USA, this
instrument has been tested to the requirements of UL61010a-1.
Safety
High voltages are present in this instrument. Maintenance and repair of internal parts must be performed
only by TA Instruments or other qualified service personnel.
Electrical Safety
You must unplug the instrument before doing any maintenance or repair work; voltages as high as
125/250 VAC are present in this system.
Lifting the Instrument
The Nano ITC is not a portable instrument. In order to avoid injury, particularly to the back, please follow
this advice:
WARNING: If this instrument is used in a manner not intended or specified in this manual, the
protection provided by the instrument may be impaired.
DANGER: High voltages are present in this instrument. Maintenance and repair of
internal parts must be performed only by TA Instruments or other qualified service
personnel.
WARNING: Use appropriate care when unpacking or moving the instrument. It may be too
heavy for some individuals working alone to handle safely.
To Next Page
Loading...
Need help?
General
