TA Q Series User Manual

TMA Q Series Getting Started Guide
24
Choosing a Location
Because of the sensitivity of TMA experiments, it is important to choose a location for the instrument using the
following guidelines. The TMA should be:
In ... a temperature-controlled area.
... a clean, vibration-free environment.
... an area with ample working and ventilation space.
On ... a stable work surface.
NOTE: Placing the TMA on a stable, vibration-free work surface is very important to instrument
performance.
Near ... a power outlet (120 Vac, 50 or 60 Hz, 15 amps, or 230 Vac, 50 or 60 Hz, 10 amps if configured with
a step down transformer).
...your TA Instruments thermal analysis controller.
...sources of compressed lab air and purge gas supplies with suitable regulators.
CAUTION: Your air source must be clean, dry, and oil-free to ensure proper operation
of the TMA.
Away
from ... any flammable materials.
... dusty environments.
... exposure to direct sunlight.
... direct air drafts (fans, room air ducts).
... poorly ventilated areas.
... noisy or mechanical vibrations.
CAUTION: Drying out the instrument may be needed, if it has been exposed to humid
conditions. Certain ceramic materials used in this equipment may absorb moisture,
causing leakage currents to exceed those specified in the applicable standards until
moisture is eliminated. It is important to be certain that the instrument ground is
adequately connected to the facilities ground for safe operation.
Run the following method to dry out the TMA:
1 Ramp at 10°C/min to 400°C
2 Isothermal for 30 min.

TA Q Series Specifications

General

Brand	TA
Model	Q Series
Category	Measuring Instruments
Language	English