TMA Q Series Getting Started Guide
33
Power Entry Module
Reset Button
Power Switch
The power switch is located at the rear of the instrument. It is part of the
assembly called the power entry module, which also contains the power
cable connection and fuses. The power switch is used to turn the
instrument on and off.
Power Cable
NOTE: A <HAR>-marked (harmonized) power cable
meeting the standards of the country of installation is
required for the European Economic Area.
Install the power cable as follows:
1. Make sure the TMA POWER switch is in the Off (0) position.
2. Plug the power cable into the TMA power entry module.
CAUTION: Before plugging the TMA power cable into the wall outlet, make sure the
instrument is compatible with the line voltage. Check the label on the voltage con-
figuration unit panel to verify the voltage.
3. Plug the power cable into the wall outlet.
To Next Page
Loading...
Need help?
General
