Taie FU48 - Modification of Output Module

Program edit flow-chat
START
Set PTN
SetSV_n
SetTM_n
SetOUTn
YES Edit next
se
g
ment
?
NO
YES Edit next
pattern
?
NO
ReturnPV/SV
END ※ n : 1~8
1. Choose program pattern number
Parameter LED display Description Default Level
PTN 1 leveL 1 81~1 noitceles nrettap margorP
2. Setting segment n target SV
Parameter noitpircseD yalpsid DEL Default Level
SV_n 1 leveL 0 )8~1=n( VS n tnemgeS
3. Setting segment n target TM
Parameter noitpircseD yalpsid DEL Default Level
Se
g
ment 1 execute time settin
g
, this paramete
r
determines the link between a segment and a
segment or pattern and pattern
TM_n
END(
-
1)
:
p
ro
g
ram en
d
i
n t
hi
s se
g
ment
0.00 : program step change in this segment 0 Level 1
0.01~99.58 : program in this segment execute
time
99.59 : program continue execute this segment
no end
TM setting explain：
In segment_5(SEG_5) setting TM =END  When the program finishes segment_4(SEG_4), program end and display “END”
message, can’t enter next segment.
In segment_5(SEG_5) setting TM =0.00  When the program finishes segment_4(SEG_4), enter next segment, SV
change suddenly.
In segment_5(SEG_5) setting TM =10.00  When the program finishes segment_4(SEG_4), enter next segment
and executing TM_5 setting value.
In segment_5(SEG_5) setting TM =99.59  When the program finishes segment_4(SEG_4) , enter next segment and executing
continuously.
4. Setting segment n target OUTn
Parameter noitpircseD yalpsid DEL Default Level
OUTn 1 leveL 0.001 )8~1=n( timil tuptuo n tnemgeS
51 FY/FU operation manual