18
●
Your T2020
II
may be programmed to queue incoming calls. If this feature is enabled, the caller’s
identity is put in the queue after the ringing stops. All other call indicators are cleared when the
received call has been queued. (Refer to the section ‘Call Queuing’ for more information.)
●
If the call was not queued and you are still unable to answer the call, the radio indicates that a call
was received in your absence by leaving the CALL indicator flashing.
●
If you do not wish to answer a call, the ringing may be cancelled at any time by pressing any of the
control head keys. (The function associated with the key you press will not be invoked.) Note that
if the caller’s identity was displayed and the call was still not answered, pressing the Enter (
)
key clears the call and initiates an immediate call-back to the caller.
●
If you are one of the recipients of a group call, your radio only sounds a single sequence of the
ringing tone,
burr burr
. The caller then broadcasts a message to all members of your group.
To Next Page
Loading...
Need help?
General
